Screw fastening method that is complicated to fasten and disassemble may cause loosening

Since it is a screw fastening method, the fastening and disassembling process is complicated (3-5 minutes)
and there is a possibility (10%) that the screw will loosen within 5 years. There is a risk of fracture and loosening of the screw of the fixture
and abutment due to the lack of occlusal force buffering, and there is a risk of bone tissue destruction if the bone density is low.
When confirming the connection, an X-ray check procedure is required, and when installing a prosthesis,
various deficiencies such as the possibility of gum disease due to the use of adhesive may occur.

One-touch simple fastening thru elastic structure

Existing screw-type implants use screws for fastening the abutment and adhesives for prosthesis installation.
If the entire process from adhesive removal after the adhesive hardens was complicated, One Touch Implant does not need screws and adhesives.
The entire process of fastening and prosthesis installation is quick and easy.

Implementation of occlusal force buffering function similar to natural teeth

Existing implants have problems such as screw fracture, alveolar bone fracture, fixture fracture,
and screw loosening because there is no function to buffer occlusal force.
However, the one-touch implant has the function of buffering the occlusal force similar to that of natural teeth, thus solving the existing problems.

No risk of periodontal disease from luting

Unlike conventional implants, one-touch implants are neat because there are no holes in the occlusal surface of the prosthesis.
In addition, since there is no need for adhesives in the process of fastening artificial teeth, the procedure is quick
and there is no worry of periodontal disease caused by excess adhesive.

No need to remove the abutment below 30 degree

Existing products generally make the taper angle of the abutment less than 12°, so if the insertion angle between fixtures is more than 12°,
it is necessary to delete the abutment or create a custom abutment to secure the prosthesis pathway,
but one-touch implants If the insertion angle between fixtures is less than 30°, there is no need to delete abutment.

Ability to mitigate food impaction between implants and natural teeth :
In the case, natural teeth are placed in the front and the implant is placed in the rear,
the existing implant system does not have the buffering occlusal force from opposing teeth which worse food impaction.
So the anterior natural teeth protrude. However, one-touch implant buffer occlusal force and reduces the protrusion.